Also, confirm at this time-After the lower cable is installed, pull down the baffle.

Remember, the side with the blue tape should face toward the Ethernet interface. I left it running in my office over the weekend, and now that Ive come back its happened again. Before it hangs, it can record motion detect videos and upload them to google drive using rclone. Power is controlled by an external ATtiny85 and the Raspberry Pi only needs to signal when its done with its work. 1 Im trying to run my Pi Zero W as a motion detecting camera using RPI cam web interface but it keeps hanging after a few hours at most. This camera will take a picture every 5 minutes with a RPi camera and send it over WiFi. Insert the ribbon cable into the CSI interface. Im building a Raspberry Pi Zero W based off-grid WiFi camera setup. The HKCam utilizes a Raspberry Pi Zero W and a 3D printed enclosure to allow users to create their own security camera compatible with Apples HomeKit for less than 30. Make sure that the yellow part of the PCB (the side with the words) is perfectly installed (you can lightly press the yellow part to ensure a perfect installation). Pick up your camera module, and tear off the plastic protective film attached to the lens. Install the Raspberry Pi camera moduleįollow the steps below to connect the Raspberry Pi camera module to the Raspberry Pi:įind the CSI interface (the CSI interface is next to the Ethernet interface) and lift the dark tape.ģ.

The still picture resolution is 2592 X 1944

Pi zero w camera setup